• 站内检索
    高级检索
  • 最新录用
    更多
文章摘要
麻薯配方与3D打印特性研究
3D Printing Physical Properties of Mochi as Affected by Different Compositions
  
DOI:10.3969/j.issn.1673-1689.2020.04.010
中文关键词: 麻薯  配方  打印温度  喷头直径  质构特性  流变特性
英文关键词: mochi,composition,extruding temperature,nozzle diameter,texture properties,heolo- gical properties
基金项目:
作者单位
杨帆 江南大学 食品学院江苏 无锡 214122 
张慜 江南大学 食品学院江苏 无锡 214122 
王维琴 海通食品有限公司浙江 宁波 315000 
摘要点击次数: 9
全文下载次数: 8
中文摘要:
      以糯米粉、水、异麦芽糖浆、高麦芽糖浆为主要原料,研究打印温度、喷头直径以及糯米粉-水配比对麻薯样品的流变特性及质构特性的影响,并考察不同工艺条件下的打印产品的成型效果。结果表明:当配方为m(糯米粉)∶m(水)∶m(异麦芽糖浆)∶m(高麦芽糖浆):m(芝麻油)=29.37∶33.99∶16.20∶19.44∶1.00,喷头挤出温度为30 ℃及喷头直径为0.8 mm时,样品的流动性较好,对应的打印产品成型效果也较好。
英文摘要:
      In this paper, glutinous rice flour, water, isomalt maltose syrup and high maltose syrup were used as the main raw materials of the mochi to study the effects of extruding temperature, nozzle diameter, and glutinous rice flour/water ratio on the rheological and texture properties of the printed samples of the mochi. Besides, the modeling effect of printed samples of the mochi under different technological conditions was also investigated. The results showed that when the formula was glutinous rice flour: water: isomaltose syrup:high maltose syrup:sesame oil = 29.37:33.99:16.20:19.44:1.00 based on weight, the extruding temperature was set to 30 ℃ and the nozzle diameter was set to 0.8 mm, the flowability of the material was good, and the corresponding printed products also had the best modeling effect and the best intact shape which matched with the targeted geometry.
查看全文   查看/发表评论  下载PDF阅读器